MPD060A HITACHI control module

MPD060A HITACHI control module

MPD060A HITACHI control module

The external input of the base unit can be used as an interrupt input. When there is an interrupt input, the corresponding interrupt procedure can be executed.

The external output of the base unit can be set to the pulse-width modulation (PWM) output. In this case, the output is specified by

Pulse with free frequency and duty cycle of 0- 100 %. Up to 4 points of output can be set, including the pulse train output.

The external output of the base unit can be set as a pulse output. In this case, the output is the duty cycle at the specified frequency is

30 to 70 % of the veins. Up to 4 points of output can be set, including PWM output.

It provides the function of simulating input for 23 - point type and analog sheath unit. Its resolution is 12 bits and can be selected as

Current of 0-.20 mA and 4- 20 mA (for analog display unit only) or o-10V and -10-+10V (only

Voltage input for analog expansion unit).

The simulation output function is provided for the 23 - point type and the analog expansion unit. Its sorting rate is 12 bits and can be selected as

Current of 0-20 mA and 4-20 mA (only used in analog display unit) or voltage output of 0-10 v.

The 14 point 23 point and 28 point types have two potentiometer inputs through which the set values can be changed even without the use of a programmer.

The 23-point and 28-point types can be fitted with a dedicated battery so that it can remain in memory even after the body is powered down

The data. In addition, the calendar clock signal in the 23 and 28 o 'clock types can also be maintained. Battery type is optional EH-MBAT)=

Please refer to Chapter 15 4 for battery fault detection.)