Product Description

The GE Drive Control/LAN Communications Board DS200DKLBG1ABB features four displays with 10 characters on each display. It also features 16 LEDs and three jumpers. It also has one 40-pin connector. The board dimensions are 8.5 inches by 11 inches and it has one hole in each corner for installation in the board rack in the drive. When you arrange the board in the rack, you will find that the holes on the board align with matching holes in the rack structure. During the replacement you can remove the four screws from the board you are removing and keep the screws together for use when you attach the replacement board. If the screws also have washers keep them also and use them when you install the new board. They help protect the board from damage if the screws are attached too tightly. If the screws are too tight they might crack the board or otherwise damage the board.

The three jumpers each has an identifier printed on the board. One jumper is identified as JP1, one as JP2, and one as JP3. Some of the jumpers are available to change the configuration of the board. The written material supplied with the original board describes the functions of the jumpers. However, when you replace the original board, you can match the settings of the jumpers on the defective board on the replacement board. Place the boards side-by-side on a static protective surface and locate the jumpers by identifier and move any jumpers on the replacement board.