Product Description

DS200DMCAG1AGB GE Interface Board 

The DS200DMCAG1AGB is a circuit board component fabricated by General Electric for use in the Speedtronic Mark IV system.  The first of the GE Speedtronic systems to offer a triple modular redundant design, the Mark IV significantly reduced downtime caused by equipment issues.  The DS200DMCAG1AGB is available from AX Control as liquidated new-used stock and as reconditioned used units. 

The DS200DMCAG1AGB is an Interface board.  It is a large rectangular board with factory-made drill holes located along the board’s edges including in each corner of the board, as well as in the board’s center.   It is marked for alignment on two edges.  It carries the GE logo and several identifying codes.   The unit has one female and four male vertical cable connectors, as well as several vertical pin header connectors.  There are several stab-on connectors located near a cluster of high-voltage electrolytic capacitors in the upper left corner of the board. 

Additional components on the surface of the DS200DMCAG1AGB include jumper switches, fifteen resistor network arrays, a toggle switch marked “reset,”  four LED units with four, three, or two lights per unit, one inductor coil, and two heat sinks with mounted components.  There is an auxiliary board mounted to the DS200DMCAG1AGB’s surface that is populated with several integrated circuits, and an additional fifty integrated circuits on the board’s primary surface.  The DS200DMCAG1AGB uses diodes, ceramic and polyester vinyl capacitors, and metal film resistors.  

For more information about the DS200DMCAG1AGB, including installation and handling instructions, please refer to user guides or product manuals from General Electric.