Product Description

The GE Generator Control Turbine Board DS200CVMAG3A contains two 16-pin connectors and one 2-pin connector. The board also is populated with 6 test points. The 16-pin connectors are used to connect to ribbon cables and the ribbon cables carry control signals to multiple components and boards in the drive.  The ribbon cables are easy to damage because of the fine wires that connect to the plastic connector. Always hold the ribbon cable by the plastic connector when you pull it out of the connector on the board. With one hand steady the board to keep it  from moving and with the other hand grasp the connector and pull it out. If you can, follow the ribbon cable to the other end and make sure it is fully seated in the connector.

If you find the board is not working properly after you start the drive, you might suspect the ribbon cables and visually inspect the fine wires where they connect to the plastic connector. If you notice that one or more wires might have disconnected from the connector, replace the ribbon cable.

The 6 test points are a useful tool for diagnosing the board. The test points are designed to enable you to isolate and test one specific circuit in the board. Only a qualified individual should be testing the board due to the current in the board and the surrounding components. Make sure you use a tester that is suitable for the purpose and is calibrated for the task.