Product Description

The GE IAC2000I Power Supply Interface Board DS200IMCPG1CDB can be connected through a cable to the DS200SDCC Drive Control Board. Connect the cable to the 1PL connector on the Drive Control Board. The GE IAC2000I Power Supply Interface Board DS200IMCPG1CDB is engineered to operate under conditions with high-voltage current and it is equipped with eight fuses to protect it from overcurrent. It is important to check the fuses if you suspect one is blown. You can easily locate the fuses and check the contact in each fuse and see if it is intact.

You must perform the visual inspection without touching the board or any other component in the drive. The board and all components must be considered to be connected to high voltage to avoid the risk of electrical shock, electrical burns, and damage to components.

To replace a fuse you must remove all current to the drive.  The best practice is to remove the fuses of the power supplies that provide power to the drive.  This is a reliable method of removing power.  The next step is to use a testing device to check for the presence of power. Make sure the tester is appropriately calibrated for the purpose and is approved by a certifying organisation. Make sure the probes are in good condition and any insulation is not worn or frayed.

When you are sure no current is present, use one hand to remove the blown fuse from the connector. Press an identical fuse into the connector.