Product Description

The GE Contactor Driver Board DS200CDBAG1A opens and closes a contactor.

Consider that the GE Contactor Driver Board DS200CDBAG1A is revised periodically to improve the components, reliability, and operation of the device. However, compatibility between all revisions is assured. For example, you can purchase the latest version of the board and install it in your drive and it will be compatible with the older version you have removed.

If the need arises to replace the board, installation is easy and quick. This is due to the design of the drive which provides easy access to the board. For safety reasons and to protect all components, you must remove power to the drive. Wait several minute for all electrical power to be removed. Then test any circuits to make sure all power is removed before touching them with your hands.

Open the cabinet door of the drive where the damaged board is located. You might find that there are multiple wires connected to the damaged board. Before you remove them label any that do not have labels to make installation easier. Connector 1TB features a 2-part connector. Use a screwdriver to separate the two sections and disconnect the connectors from the board.

One jumper is located on the board that is reserved for use by the factory during manufacturing. It is used for testing. It is a 3-pin jumper and pins 1 and 2 should remain covered. Do not attempt to change the position of the jumper.