Product Description

The GE Cell State Sensor Board DS200CSSAG1BBA contains two 40-pin connectors and is 4 inches in height and 11 inches in width. It also contains one 4-pin connector and one 9-pin connector. Before the GE Cell State Sensor Board DS200CSSAG1BBA is installed, it is important to inspect the area around the drive for conditions that might compromise the safety of the installers and the other equipment around the drive. First the installer should have an assistant or other individual working on the installation. This is commonly referred to as a buddy system. If an emergency occurs, the individual can provide assistance, call for emergency help, or shut off the emergency power shut off to the drive.

Another consideration is that the floor and surrounding area should be inspected for hazards. Any moisture on the floor must be dried before proceeding to reduce the chance of electric shock. Also, remove any two-prong electric cords and devices connected to them. The two-prong electric cords are not grounded and pose a serious risk or shock. The floor must also be free of all oil, grease, loose tools, and other trip hazards.

The next guideline to follow is that all power must be shut off to the drive. It is best to confer with persons who were involved in the installation of the drive and understand the power sources and cable routing used during the installation. If DC power is used to power the drive, you can remove the fuses from the power supply to disconnect the power.