Product Description

The GE IOS + Power Connect Board DS200DPCAG1 features 3 terminal blocks for 3 wires in each block and one toggle switch. The DS200DPCAG1 also features one fuse and four 26-pin connectors. The terminal blocks enable the installer to attach a maximum of 9 wires to the board. To remove the wires during the replacement of the board, first note where each wire is attached on the terminal block. All the connectors have a unique identifier and you need to write on a label the identifier and attach it to the wire. Use a screwdriver to loosen the screws that holdthe wire in the terminal. Remove the wire from the block.

Wear a static protective wrist strap when you work with the replacement board. The wrist drains away the static that accumulates on your body or the board. One end of the strap wraps around your wrist and the other clips to a metal surface that is not painted.   To further prevent damage from static, keep the board in the protective bag until you are ready to install it in the drive. Another way to keep the danger of static at a minimum is to refrain from walking around with the board in your hands.

Insert each wire into the terminal indicated on the label you created and while holding  the wire in the terminal, tighten the screw to hold in place. Don’t over tighten the screws because it might damage the wire or damage the terminal block.