Product Description

The DS200DPCAG1ADB board functions as a DC power connect card that works in conjunction with the Mark V turbine control system.  This is a GE system, designed specifically for the management and control of industrial steam and gas turbines.  

The DS200DPCAG1ADB is a long, narrow board that has been factory drilled at each corner and along the long board edges.  These holes are ringed with conductive materials, and are used to offer mounting support options.    The board is marked with several codes including wiring and location codes, and also carries the GE logo.  

Components on the board include several small terminal blocks, stab-on connectors that allow for surface wiring connections, a switch component, vertical pin connectors, and a jumper switch.  There are four 26-pin connectors used for ribbon cables.  These carry signals to/from the drive or other components within the drive.  Make sure to handle all ribbon cables carefully as the wires on the cables can easily break.  The best practice is to remove or insert the ribbon cable using the plastic connector at its end rather than the ribbon cable.  Do this by holding the end connector and aligning it with the board connector.  Press it into the connector.  When removing, hold the edges of the cable’s connector with your fingers and pull gently until it disconnects from the board.  Do not pull from the ribbon cable. The board also has a 250V fuse located close to a short board edge. 

For more details, please refer to General Electric Mark V manuals and user guides.